Board indexPortal
Last visit was: It is currently 17. Feb 2020 00:07

All times are UTC + 1 hour

Post new topic Reply to topic  [ 1 post ] 
FollowersFollowers: 0
BookmarksBookmarks: 0
Views: 171

 Post subject: KNX-compatible device based on STM32G071 MCU with Arduino flavour
PostPosted: 11. Jul 2019 16:41 

Joined: 08.2018
Posts: 3
Gender: None specified
Hello, I would like to announce my new device originally based on selfbus, which I've ported to STM32 platform.

I've designed a custom STM32-based board but one can use a STM's Nucleo development board as well. Bus-coupling interface is quite simple because of STM32's built-in DAC (threshold voltage for pulse detection) connected to built-in comparator (comparing threshold voltage with bus voltage) that triggers a timer. The rest of the processing is pure selfbus.

My version is compatible with Arduino so one can write a single .ino file and compile the firmware from Arduino IDE or VS Code.

See my project log, Project GitHub page with schematics etc. and Library GitHub page.

I also plan to improve the "OTA" firmware updating - send only a diff between old and new firmware, allow to activate bootloader after device (bus) reset by sending a magic telegram instead of triggering the physical prog button (which will also work).

Any comments and pull requests are welcome ;)

Offline Profile  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 1 hour

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Powered by phpBB® Forum Software © phpBB Group | Theme created
phpBB3 free Forum by | All Rights Reserved.
» Contact & Abuse Support-Forum Gooof Webdesign free forum Dein Forumo Forum web tracker